On 1 February, Swiss International Air Lines flight 40 experienced an issue with its number 1 engine—the engine on the left side of the aircraft—and diverted to Iqaluit in northern Canada. After flight LX40 landed, the logistical challenge of getting passengers to their destinations—and a new engine for the aircraft—began.
Swiss flight 40, a Boeing 777-300ER with two General Electric GE90-115B engines, en route from Zurich to Los Angeles, was off the coast of Canada when the engine automatically shut down after detecting a fault. The crew decided to divert to Iqaluit and landed a little less than 2 hours later.
A Swiss A330 was dispatched as LX7002 from New York to retrieve the crew and cargo and deliver Swiss engineers to begin the engine inspection process.
Cargo, passengers, and crew from the 777 were transferred to the A330, which then departed as LX7003 to New York, where passengers were sent onward to their final destinations.
A New Engine
After inspections, it was determined the GE90 engine needed replacing. An Antonov An-124 was chartered to pick up the engine from Zurich and deliver it to Iqaluit. The aircraft also brought the necessary equipment to perform the engine change.
The new engine arrived on 4 February and crews began work to remove the faulty engine and install the new engine. Members of the Iqaluit aviation community were able to document much of the process.
@flyswiss 777 #engine #change is moving along nicely, #tent is now #erected and #heat is #blasting inside pic.twitter.com/ksO1L8bH6M
— YellowBonz69 (@BonzBrooks) February 5, 2017
Due to the cold temperatures (reaching into the -30 degrees Celsius range), engineers erected a specially designed tent around the engine to facilitate their work.
#tent empty#wow,so #impressed #old #engine is out and #new #GE90 being #prepped for #installation onto the #pylon @flyswiss #swissair 777. pic.twitter.com/eMguWudWQG
— YellowBonz69 (@BonzBrooks) February 6, 2017
The engine pylon and open tent with the engine removed.
@FlySWISS @FlySWISS_US @GEAviation #boeing 777 new #engine is installed onto the pylon already. #awesome pic.twitter.com/dfXqfdtFOP
— YellowBonz69 (@BonzBrooks) February 7, 2017
The new GE90-115B installed on the engine pylon under the 777’s wing.
@FlySWISS 777 #engine runs have begun, estimates test time is 45 minutes @GEAviation #powerplant sounds great pic.twitter.com/3Wa8nBOukP
— YellowBonz69 (@BonzBrooks) February 8, 2017
After successful installation, the new engine is tested on the ground before the aircraft departs for Zurich.
Time to Go Home
With the engine change complete, HB-JND departed Iqaluit as LX5177. After spending a week on the ground in Iqaluit, the 777 was back in Zurich.
#swiss #lx40 is back at home in #zurich pic.twitter.com/diAoNu8FMS
— sandy vollmar (@sandyvollmar) February 9, 2017
One Response